Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| other:other [2021/08/16 02:19] – [Other] formlab | other:other [2021/08/16 02:20] – [Sanding PLA] formlab | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| ===== Sanding PLA ===== | ===== Sanding PLA ===== | ||
| - | {{: | + | {{: |
| Sanding 3D prints makes it appear matte.\\ | Sanding 3D prints makes it appear matte.\\ | ||
| - | {{: | + | {{: |
| - | Removing material is best done by a sanding disk on a Dremel. | + | Removing material is best done by a sanding disk on a Dremel. |
| * Put on eye protection. | * Put on eye protection. | ||
| * Set the speed low (the dial should indicate the number 10). This is to keep the temperature low in order to avoid melting the plastic. This way it chips off, rather than gunking up into blobs. | * Set the speed low (the dial should indicate the number 10). This is to keep the temperature low in order to avoid melting the plastic. This way it chips off, rather than gunking up into blobs. | ||