This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |
| openbuilds_acro:workflow_-_how_to_plot [2024/02/19 01:24] – [Load the Gcode] formlab | openbuilds_acro:workflow_-_how_to_plot [2024/02/19 01:24] (current) – [Load the Gcode] formlab |
|---|
| |{{:openbuilds_acro:acro_open_file_02.png|}}|In Openbuilds CONTROL, click 'Open Gcode'.| | |{{:openbuilds_acro:acro_open_file_02.png|}}|In Openbuilds CONTROL, click 'Open Gcode'.| |
| |{{:openbuilds_acro:acro_gcode_file_01.png|}}|Select the Gcode file that was downloaded by the svg2gcode website.| | |{{:openbuilds_acro:acro_gcode_file_01.png|}}|Select the Gcode file that was downloaded by the svg2gcode website.| |
| |<wrap hi>image needed</wrap>|Click on the Gcode editor-tab and scroll all the way down and remove the line containing 'M2'. This gcode command results in a glitch that puts the pen back on the paper after the whole plot has finished. It's better that the pen stays up after plotting. No need to save the gcode file. The changes are already active.</wrap>| | |<wrap hi>image needed</wrap>|Click on the Gcode editor-tab and scroll all the way down and remove the line containing 'M2'. This gcode command results in a glitch that puts the pen back on the paper after the whole plot has finished. It's better that the pen stays up after plotting. No need to save the gcode file. The changes are already active.| |
| |<wrap hi>image needed</wrap>|Click again on the '3D-view' tab and double check the dimensions on the X and Y axis. <wrap lo>Pan with CTRL pressed to pan the view around and use the scroll wheel to zoom.</wrap>| | |<wrap hi>image needed</wrap>|Click again on the '3D-view' tab and double check the dimensions on the X and Y axis. <wrap lo>Pan with CTRL pressed to pan the view around and use the scroll wheel to zoom.</wrap>| |
| |