lmi_3d_scanner:i_m_getting_bad_scan_results_-_troubleshooting

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
lmi_3d_scanner:i_m_getting_bad_scan_results_-_troubleshooting [2019/10/21 06:42]
formlab
lmi_3d_scanner:i_m_getting_bad_scan_results_-_troubleshooting [2019/10/22 00:47] (current)
formlab
Line 9: Line 9:
       * measure and re-set the Z-max value       * measure and re-set the Z-max value
     * Turn on bounding box: this way it's easier to spot if a scan contains information or not.     * Turn on bounding box: this way it's easier to spot if a scan contains information or not.
-    * reinstall FlexScan3D 
  
   * Using the rotary table, my scan is scattered in a circular pattern   * Using the rotary table, my scan is scattered in a circular pattern
Line 24: Line 23:
     * increase pattern delay. Check the scan-images to see if each image has the right projected pattern on it.     * increase pattern delay. Check the scan-images to see if each image has the right projected pattern on it.
  
 +  * 3D object rotates slowly and can't be stopped
 +    * stop "demo mode" in the contextual menu.
 +
 +
 +=== Special cases ===
 +  * scanning and processing takes long (capture time: ± sec, processing time: ±70 sec)
 +     * the bounding box is empty
 +     * system check is OK
 +     * making a scan to define the cut plane doesn't take abnormally long
 +     * Generate: "capture only" is also slow. Generating a mesh from the images doesn't work
 +     * the problem persists after restore defaults and reboot
 +     * The scan-images look good.
 +     * This problem was with FlexScan3D V3.3.5.8 (64bits)
 +     * A reinstall of the program fixed these problems
  
  • lmi_3d_scanner/i_m_getting_bad_scan_results_-_troubleshooting.txt
  • Last modified: 2019/10/22 00:47
  • by formlab