Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
lmi_3d_scanner:i_m_getting_bad_scan_results_-_troubleshooting [2019/10/21 06:42] – formlab | lmi_3d_scanner:i_m_getting_bad_scan_results_-_troubleshooting [2019/10/22 00:47] (current) – formlab | ||
---|---|---|---|
Line 9: | Line 9: | ||
* measure and re-set the Z-max value | * measure and re-set the Z-max value | ||
* Turn on bounding box: this way it's easier to spot if a scan contains information or not. | * Turn on bounding box: this way it's easier to spot if a scan contains information or not. | ||
- | * reinstall FlexScan3D | ||
* Using the rotary table, my scan is scattered in a circular pattern | * Using the rotary table, my scan is scattered in a circular pattern | ||
Line 24: | Line 23: | ||
* increase pattern delay. Check the scan-images to see if each image has the right projected pattern on it. | * increase pattern delay. Check the scan-images to see if each image has the right projected pattern on it. | ||
+ | * 3D object rotates slowly and can't be stopped | ||
+ | * stop "demo mode" in the contextual menu. | ||
+ | |||
+ | |||
+ | === Special cases === | ||
+ | * scanning and processing takes long (capture time: ± sec, processing time: ±70 sec) | ||
+ | * the bounding box is empty | ||
+ | * system check is OK | ||
+ | * making a scan to define the cut plane doesn' | ||
+ | * Generate: " | ||
+ | * the problem persists after restore defaults and reboot | ||
+ | * The scan-images look good. | ||
+ | * This problem was with FlexScan3D V3.3.5.8 (64bits) | ||
+ | * A reinstall of the program fixed these problems | ||