Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
lmi_3d_scanner:configuring_scan_volume [2021/01/14 02:52] – [3. Focus projector] formlab | lmi_3d_scanner:configuring_scan_volume [2021/01/14 02:58] (current) – [6. Calibrating] formlab | ||
---|---|---|---|
Line 104: | Line 104: | ||
{{: | {{: | ||
Match the size of the squares of the calibration card.\\ | Match the size of the squares of the calibration card.\\ | ||
- | Make sure sensible Filter values are set. | + | Make sure sensible Filter values are set. (no documentation found on where the values are measured from. Possibly the CCD location of the camera' |