Show pageOld revisionsBacklinksBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== Engraving large pockets ====== {{:isel_icv4030:engraving-large-pockets-poster.jpg?400|}}\\ To engrave pockets that are wider than the chamfer tool's diameter, follow these steps: * In this example, the engraving should be 3mm deep * **OP 1**: 2D pocket. * Set bottom height to the selected contour with an offset of -3mm. * under radial stock to leave, enter the radius of the V-bit at 3mm from the tip * to calculate this offset, make a cross-sectional drawing of the V-bit and measure the diameter at the correct distance (3mm) from the tip. Divide this length to become the radius. * {{:isel_icv4030:engraving_large_pockets-calculate_radial_offset.png?400|}}\\ * **OP 2**: Engraving operation with V-bit * Set bottom height to the selected contour with an offset of -3mm. isel_icv4030/engraving_large_pockets.txt Last modified: 2020/02/19 06:54by formlab