Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
isel_icv4030:engraving_detailed_images [2023/01/25 07:43] – [Using Rhino] formlab | isel_icv4030:engraving_detailed_images [2023/04/03 06:43] (current) – [Using Rhino] formlab | ||
---|---|---|---|
Line 57: | Line 57: | ||
* If extrusion fails | * If extrusion fails | ||
- | * shift + click the top (and bottom) surface and delete | + | |
+ | | ||
* select the walls and ' | * select the walls and ' | ||
- | * select | + | * enter the command '' |
- | * if you selected everything, hide it with ''alt + h'' | + | * if the command found one or a few super small walls, delete them. If there's no gap, that should be good enough to go. If there' |
- | * maybe / hopefully there are tiny vertical wall-pieces | + | |
- | * Look at them, | + | |
- | * memorise their positions | + | |
- | * delete them | + | |
- | * Unhide | + | |
- | * fix the gaps with the '' | + | |
* When the walls look OK again, click the icon '' | * When the walls look OK again, click the icon '' | ||
* Repeat for the bottom parts if necessary | * Repeat for the bottom parts if necessary |