Show pageOld revisionsBacklinksBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== Plasticine ====== Keep temperature in mind. Plasticine will under-extrude when below room temperature (±20°C). ===== Loading material ===== - Push the piston to the other end of the tube. Do not fasten the rear collar yet. - Warm up plasticine in your hands and push it into the tube. Make sure that **no air bubbles** are formed. The piston should be pushed backwards by the plasticine. This can be tough, but apply a steady amount of pressure will push the piston back. - Fasten the rear collar. - Push the nozzle into the material. - Screw it down with the front collar. - Attach it to the ''EMO-25'' tool head - Can be used over and over again. This is a good material for testing. Proven slicer profiles? ===== Cleaning ===== - Hot water & soap? hyrel/plasticine.txt Last modified: 2020/10/12 06:26by formlab