Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
hyrel:hyrel [2020/10/12 06:50] – [Tests] formlab | hyrel:hyrel [2021/01/26 01:38] (current) – [Hyrel] formlab | ||
---|---|---|---|
Line 38: | Line 38: | ||
* [[hyrel: | * [[hyrel: | ||
* [[hyrel: | * [[hyrel: | ||
+ | * [[hyrel: | ||
Line 104: | Line 105: | ||
* Printer sometimes doesn' | * Printer sometimes doesn' | ||
* After stopping the print (Kill function), **reset Z-zero** | * After stopping the print (Kill function), **reset Z-zero** | ||
+ | * It seems that Repetrel doesn' | ||
Line 111: | Line 113: | ||
* '' | * '' | ||
* '' | * '' | ||
+ | * Davo 01/10/2015 | ||
+ | * **Reset**: will reboot the 407 motion controller | ||
+ | * **Aux**: will toggle a relay, which can be used to allow or deny power to an auxiliary item like an air filter or heater | ||
+ | * **Respond**: | ||
+ | * If you hear tics in a regular or random pattern, chances are you're printing with ' |