Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
hyrel:hyrel [2020/10/12 06:29] – [Tests] formlab | hyrel:hyrel [2021/01/26 01:38] (current) – [Hyrel] formlab | ||
---|---|---|---|
Line 38: | Line 38: | ||
* [[hyrel: | * [[hyrel: | ||
* [[hyrel: | * [[hyrel: | ||
+ | * [[hyrel: | ||
Line 97: | Line 98: | ||
* 5mm/s or 8mm/s is not a problem when material is at room temperature (when the lab is not cold) | * 5mm/s or 8mm/s is not a problem when material is at room temperature (when the lab is not cold) | ||
* Try printing again with a heated bed (20° | * Try printing again with a heated bed (20° | ||
- | * Unrelated to this problem: I should try out more agressive | + | * Unrelated to this problem: I should try out more aggressive |
+ | |||
+ | |||
+ | ==== Issues ==== | ||
+ | * Printer sometimes doesn' | ||
+ | * After stopping the print (Kill function), **reset Z-zero** | ||
+ | * It seems that Repetrel doesn' | ||
+ | |||
+ | |||
+ | |||
+ | ==== Random knowledge ==== | ||
+ | * '' | ||
+ | * '' | ||
+ | * '' | ||
+ | * Davo 01/10/2015 | ||
+ | * **Reset**: will reboot the 407 motion controller | ||
+ | * **Aux**: will toggle a relay, which can be used to allow or deny power to an auxiliary item like an air filter or heater | ||
+ | * **Respond**: | ||
+ | * If you hear tics in a regular or random pattern, chances are you're printing with ' |