Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
formech_1372:formech_1372 [2023/12/18 00:45] – [General tips] formlab | formech_1372:formech_1372 [2024/03/01 01:38] (current) – [Medium Gauge Film] formlab | ||
---|---|---|---|
Line 215: | Line 215: | ||
- Press the --> arrow to go to the time value | - Press the --> arrow to go to the time value | ||
- Set the time with the up-down arrows | - Set the time with the up-down arrows | ||
+ | - When ready, press the stop / start button to start the oven | ||
==== Suggested program ==== | ==== Suggested program ==== | ||
Line 262: | Line 263: | ||
* vacuum: manual operation: start-stop technique to avoid holes if there are large cavities | * vacuum: manual operation: start-stop technique to avoid holes if there are large cavities | ||
+ | * Polypropylene sheet: 1mm | ||
+ | * No profile saved | ||
+ | * Heaters at 50% | ||
+ | * Heating: ±70 sec. Ready when sheet starts pulling flat. Might be ready much earlier too, but these values are the ones we used for testing. The plastic is very stretchy and blew holes in tiny cavities. So maybe better less heat. | ||
---- | ---- | ||