3d_modeling:blender:clean_up_occipital_3d_scan

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
3d_modeling:blender:clean_up_occipital_3d_scan [2021/10/13 03:05]
formlab [Join fragments to a single mesh]
3d_modeling:blender:clean_up_occipital_3d_scan [2021/10/13 03:07] (current)
formlab [Auto-fix holes]
Line 36: Line 36:
   * Try selecting the non-manifold vertexes again. If there are still some selected, repeat the above process, or export the object to Meshmixer to remesh it there.   * Try selecting the non-manifold vertexes again. If there are still some selected, repeat the above process, or export the object to Meshmixer to remesh it there.
  
 +The 3D print add-on for Blender is helpful in preparing your object for 3D printing: enable the add-on ''3D-Print Toolbox'' in the Blender preferences.
 ==== Delete unwanted geometry ==== ==== Delete unwanted geometry ====
 Cut away unwanted parts, like the surface the model was standing on. Cut away unwanted parts, like the surface the model was standing on.
  • 3d_modeling/blender/clean_up_occipital_3d_scan.txt
  • Last modified: 2021/10/13 03:07
  • by formlab