3D printing a single contour-line in Cura

For a graphic cross-section look.

• Move your 3D model down so it intersects with the build platform at the chosen Z-height.
• Set build plate adhesion to none
• Optional: in 'Special Modes', set 'Surface Mode' to surface. This slices just the outer contour of the 3D model and ignores the infill etc.

• Go to Extensions > Post Processing > Modify G-Code. Add script Pause at height. Change settings to:
  • Pause at: Layer No.
  • Pause Layer: 1
  • Disarm timeout: 1s
  • Standby Temperature: 0°C
• Save the G-code file to a USB stick and print.
• The printer is paused after the single layer. Navigate the printer menu to Tune > Abort to actually stop the print.

Tested on

• Ultimaker 3