====== Plasticine ======

Keep temperature in mind. Plasticine will under-extrude when below room temperature (±20°C).

===== Loading material =====
  - Push the piston to the other end of the tube. Do not fasten the rear collar yet.
  - Warm up plasticine in your hands and push it into the tube. Make sure that **no air bubbles** are formed. The piston should be pushed backwards by the plasticine. This can be tough, but apply a steady amount of pressure will push the piston back.
  - Fasten the rear collar.
  - Push the nozzle into the material.
  - Screw it down with the front collar.
  - Attach it to the ''EMO-25'' tool head

- Can be used over and over again. This is a good material for testing.


Proven slicer profiles?


===== Cleaning =====
  - Hot water & soap?