====== Tips ======

  * Cylinders can be combined for larger volume prints. 
    * M0 x0 y200 (Pauses the print and brings the tool head forward so the current cylinder can be swapped out for a new one. When ready, press continue).
  * Keep cylinders CLEAN. Dry material inside is the #1 problem.
  * No air in cylinders. Air will make the material delivery spongy. Accurate control is impossible this way.
  * manuals are at ''Desktop > repetrel > Manuals''. Check the ''Accessories'' folder for manuals about the toolheads.
  * <wrap hi>Choosing another Slicer Profile</wrap>
    * Make sure you <wrap hi>select first the project file (Main) and then the 3D object</wrap> in the project window <wrap hi>before choosing a new slicing profile</wrap>. This is a quirk of the Repetrel software. Make sure to Add consistent notes to the slicer profiles, so you can notice them in the G-code preview (they are printed on top of the file). This makes it easier to see exactly which profile you selected

====== Dialing in new material settings ======
  * Apart from the slicer profile, the tool-head controls the flow of material
      * ''Prime'': whenever transitioning from a non-printing move to a printing move.
      * ''Unprime'': whenever transitioning from a printing move to a non-printing move.
      * Adjust these settings by halving or doubling the steps and rate, making a test print and then reassessing.
      * More info: https://madprinter.org/2016/07/05/dialing-in-material-settings/