Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| projet_mjp_3600:projet_mjp_3600 [2020/07/14 03:31] – [How much does it cost?] formlab | projet_mjp_3600:projet_mjp_3600 [2025/01/13 02:11] (current) – [How much does it cost?] formlab | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| ---- | ---- | ||
| - | ===== How much does it cost? ===== | + | [[https:// |
| - | + | ||
| - | < | + | |
| - | ( build material cost + support material cost ) * material multiplier ) | + | |
| - | + | + | |
| - | ( machine time (in hours) * machine time cost ) | + | |
| - | </ | + | |
| - | + | ||
| - | * Build material cost: €515,70 per 2Kg | + | |
| - | * Support material cost: €279,72 per 2Kg | + | |
| - | * Material multiplier: 10% (build and support material * 1,1) | + | |
| - | * Machine time multiplier: €0,55 per hour | + | |
| === Design constraints === | === Design constraints === | ||
| * A hollow model needs a hole for the support material to drain out. Without a hole, the software will fill the space with building material | * A hollow model needs a hole for the support material to drain out. Without a hole, the software will fill the space with building material | ||
| - | Post production | + | === Post production |
| * Degrease object with IPA to increase adhesion for paint | * Degrease object with IPA to increase adhesion for paint | ||
| * Use a primer for UV protection | * Use a primer for UV protection | ||
| * Spray paint | * Spray paint | ||
| * Colouring the volume of the object: immerse into a mixture of acetone (30%), water (70%) and fabric paint (experimental) | * Colouring the volume of the object: immerse into a mixture of acetone (30%), water (70%) and fabric paint (experimental) | ||