Differences

This shows you the differences between two versions of the page.

--- projet_cjp_660:projet_cjp_660 [2022/02/25 05:00] – formlab
+++ projet_cjp_660:projet_cjp_660 [2022/09/30 02:01] (current) – [Pre print checks] formlab
@@ Line 2: / Line 2: @@
 {{:projet_cjp_660:projet_660.jpg|}}
+===== 3D modelling workflow =====
+  * [[projet_cjp_660:Blender workflow for color printing]]
+Issue with lines on texture in 3D Print (not visible in Blender): https://support.capturingreality.com/hc/en-us/community/posts/115001620231-Big-seams-of-the-texture-when-printing-model-on-ProJet-660-Pro
+- hmm.. texture was 2x2k. Try maybe a UV render with larger spaces between the islands?
@@ Line 8: / Line 17: @@
     * Check power status print-computer. No sleep or screen saver.
     * Raise build plate (!)
+    * Clean the parking caps.
+    * Clean the service station.
+    * Clean the spreader roller and scrapers.
+    * Clean the fast axis rails and carriage.
 ==== Post print steps and cleaning ====
-    * Leave print in build chamber for x minutes (LOOK UP DURATION)
+    * Leave print in build chamber for 2 hours to strengthen the glue.
-    * Vacuum excess core material
+    * Vacuum excess core material.
-    * Raise buildplate
+    * Raise buildplate.
-    * Clean the debris separator grille
+    * Clean the debris separator grille.
-    * Clean the parking caps
+    * Clean the parking caps.
-    * Clean the service station
+    * Clean the service station.
-    * Clean the spreader roller and scrapers
+    * Clean the spreader roller and scrapers.
-    * Clean the fast axis rails and carriage
+    * Clean the fast axis rails and carriage.
 ==== Cleaning print ====
@@ Line 78: / Line 92: @@
 ----
-===== 3D modelling workflow =====
-  * [[projet_cjp_660:Blender workflow for color printing]]
-Issue with lines on texture in 3D Print (not visible in Blender): https://support.capturingreality.com/hc/en-us/community/posts/115001620231-Big-seams-of-the-texture-when-printing-model-on-ProJet-660-Pro
-- hmm.. texture was 2x2k. Try maybe a UV render with larger spaces between the islands?