Differences

This shows you the differences between two versions of the page.

--- openbuilds_acro:workflow_-_how_to_plot [2024/09/13 05:49] – [Place the paper and define work area] formlab
+++ openbuilds_acro:workflow_-_how_to_plot [2025/02/28 04:54] (current) – [Generate Gcode] formlab
@@ Line 80: / Line 80: @@
 |{{:openbuilds_acro:acro_svg2gcode_settings_02.png|}}|<WRAP>
   * **Load the plotter settings**
-    * Download this {{ :openbuilds_acro:settings_v2.json.zip |settings-file}} and unzip it.
+    * Download this {{ :openbuilds_acro:settings_v2.1.json.zip |settings-file}} (v2.1) and unzip it.
     * On the svg2gcode-website, click 'Settings', then 'Import/Export'. Select the JSON-file you just downloaded and click Save
 </WRAP>|
@@ Line 106: / Line 106: @@
 |{{:openbuilds_acro:acro_gcode_file_01.png|}}|Select the Gcode file that was downloaded by the svg2gcode website.|
 |<wrap hi>image needed</wrap>|Click on the Gcode editor-tab and scroll all the way down and remove the line containing 'M2'. This gcode command results in a glitch that puts the pen back on the paper after the whole plot has finished. It's better that the pen stays up after plotting. No need to save the gcode file. The changes are already active.|
-|<wrap hi>image needed</wrap>|Click again on the '3D-view' tab and double check the dimensions on the X and Y axis. <br />**Pan**: right mouse button <br />**Zoom** scroll wheel.|
+|<wrap hi>image needed</wrap>|<WRAP>
+To prevent a **CRASH**: click on the '3D-view' tab and double check the dimensions on the X and Y axis.
+  * **Pan**: right mouse button
+  * **Zoom** scroll wheel
+  * **Y** axis: no higher than **1250**mm
+  * **X** axis: no wider than **820**mm
+</WRAP>|
 ==== Start the plot ====