isel_icv4030:milling_pcb_s

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
isel_icv4030:milling_pcb_s [2021/06/22 07:54] – [small holes] formlabisel_icv4030:milling_pcb_s [2021/06/22 08:07] (current) – [BAD SVG's] formlab
Line 36: Line 36:
  
  
-==== BAD SVG's ==== +==== Bad SVG's ==== 
 === Circles === === Circles ===
 {{:isel_icv4030:fusion_pcb_06.png?400|}}\\  {{:isel_icv4030:fusion_pcb_06.png?400|}}\\ 
Line 59: Line 59:
   * Add an engrave toolpath strategy and select the traces. You don't need to select the holes yet, but **make sure to select a contour line around all the traces**. That way Fusion knows at which side of the lines the tool need to be placed. I tested 0.3mm depth, but 0,2mm or shallower should work better.\\ {{:isel_icv4030:fusion_pcb_02.png?400|}}\\ {{:isel_icv4030:fusion_pcb_03.png?400|}}\\ Here you can see the cut is made on the outside of the traces.   * Add an engrave toolpath strategy and select the traces. You don't need to select the holes yet, but **make sure to select a contour line around all the traces**. That way Fusion knows at which side of the lines the tool need to be placed. I tested 0.3mm depth, but 0,2mm or shallower should work better.\\ {{:isel_icv4030:fusion_pcb_02.png?400|}}\\ {{:isel_icv4030:fusion_pcb_03.png?400|}}\\ Here you can see the cut is made on the outside of the traces.
  
-==== small holes ====+==== Small holes ====
 {{:isel_icv4030:fusion_pcb_04.jpg?400|}} {{:isel_icv4030:fusion_pcb_04.jpg?400|}}
   * Put one of the PCB drills from the Hyrel kit in a 1/8" (3.175mm) collet.   * Put one of the PCB drills from the Hyrel kit in a 1/8" (3.175mm) collet.
   * No need to ad these to the tool list in Fusion. Simulate them with a 1mm flat endmill.    * No need to ad these to the tool list in Fusion. Simulate them with a 1mm flat endmill. 
   * Take the CAM profile "PCB-Drill" from CAM Templates > PCB. This plunges the drill straight down. As it does not helix, the hole is the same diameter as the drill.   * Take the CAM profile "PCB-Drill" from CAM Templates > PCB. This plunges the drill straight down. As it does not helix, the hole is the same diameter as the drill.
  • isel_icv4030/milling_pcb_s.1624373662.txt.gz
  • Last modified: 2021/06/22 07:54
  • by formlab