Differences

This shows you the differences between two versions of the page.

--- formech_1372:formech_1372 [2025/01/13 02:12] – [PS - Polystyrene] formlab
+++ formech_1372:formech_1372 [2025/12/04 02:44] (current) – [Materials allowed in Formlab] formlab
@@ Line 12: / Line 12: @@
   * Large: ''1370 x 660mm''
+[[https://www.formlab.schoolofarts.be/pricing|What does it cost?]]
 === Pre-drying ===
   * PMMA: 70°C 4 hours
@@ Line 105: / Line 107: @@
-=== How much does it cost? ===
-  startup cost + ( plastic sheet cost * plastic sheet count * material multiplier )
-  +
-  ( machine time (minutes) * machine time cost )
-  * startup cost: €2: only when vacuum form machine is used
-  * plastic sheet cost: cost sheet, including VAT and transportation
-  * material multiplier: item cost * 1,4
-  * machine time cost: €8 per hour (€0,08333333 per minute)
@@ Line 138: / Line 129: @@
   * **Forming temp range**: ''120–160°C''
   * **Conclusion**: Easy to form and stronger than HIPS, ±50% more expensive
+  * **Lasercutting**: Speed 40, Power 40, trace 2 times
@@ Line 211: / Line 204: @@
   - Press 'program' until it goes to program 5
     - Nothing is on here yet. (This might change in the future)
-    - Press until there's an empty preset
+    - Press the --> arrow until there's an empty preset
     - In the future there might be a paper with an explanation of what programs do what. I could have a fixed entry on the list
   - Segment 1' is blinking. Use the up-down arrows to set a target temperature