Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
prepare_for_3d_printing:prepare_for_3d_printing [2022/08/22 02:53] – created formlab | prepare_for_3d_printing:prepare_for_3d_printing [2024/05/13 00:38] – formlab | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Prepare for 3D printing ====== | ====== Prepare for 3D printing ====== | ||
+ | ===== Prepare your 3D mesh ===== | ||
- | - watertight | + | * watertight |
- | - not too many intersections | + | |
- | - avoid small details (0.8mm minimum detail, but tall objects should be thinker) | + | |
- | - if part snaps together with other part: allow clearance | + | |
- | - if part snaps together with other part: make sure the part can be inserted | + | |
+ | |||
+ | ===== Slicing tips ===== | ||
+ | * If Cura is slow: set the option " |