Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
lulzbot_taz_6:lulzbot_taz_6 [2020/05/25 02:49] – formlab | lulzbot_taz_6:lulzbot_taz_6 [2021/06/17 04:24] – [Troubleshooting] formlab | ||
---|---|---|---|
Line 14: | Line 14: | ||
Y = 280 | Y = 280 | ||
- | [[:How much does FDM printing cost?]] | + | * [[:How much does FDM printing cost?]] |
+ | * [[:Filament options]] | ||
+ | |||
+ | ===== Troubleshooting ===== | ||
+ | * The printer underextrudes after ±10 - 15 minutes. | ||
+ | * This could be [[https:// | ||
===== Maintenance ===== | ===== Maintenance ===== | ||
Line 34: | Line 39: | ||
* Verify that any frame screws are tight. | * Verify that any frame screws are tight. | ||
* Check for software updates. Update Cura LulzBot Edition at [[https:// | * Check for software updates. Update Cura LulzBot Edition at [[https:// | ||
- | + |