Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| formech_1372:formech_1372 [2023/12/18 00:46] – [Control panel] formlab | formech_1372:formech_1372 [2024/03/01 01:38] (current) – [Medium Gauge Film] formlab | ||
|---|---|---|---|
| Line 263: | Line 263: | ||
| * vacuum: manual operation: start-stop technique to avoid holes if there are large cavities | * vacuum: manual operation: start-stop technique to avoid holes if there are large cavities | ||
| + | * Polypropylene sheet: 1mm | ||
| + | * No profile saved | ||
| + | * Heaters at 50% | ||
| + | * Heating: ±70 sec. Ready when sheet starts pulling flat. Might be ready much earlier too, but these values are the ones we used for testing. The plastic is very stretchy and blew holes in tiny cavities. So maybe better less heat. | ||
| ---- | ---- | ||