3d_modeling:meshmixer

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
3d_modeling:meshmixer [2020/02/10 07:23] formlab3d_modeling:meshmixer [2020/03/25 07:25] (current) formlab
Line 2: Line 2:
  
  
-[[Split 3D model]].+[[3d_modeling:Meshmixer:Clean up 3D scan]] 
 + 
 + 
 +---- 
 + 
 +[[Split 3D model|{{:3d_modeling:split_poster.jpg?400|}}]]\\  
 +[[Split 3D model]]
  
 ---- ----
Line 16: Line 22:
  
 ---- ----
 +
 +===== Quick tips =====
 +
  
 [[Select a flat surface|{{:3d_modeling:meshmixer-select-flat-areas-poster.jpg?nolink400|}}]]\\ [[Select a flat surface|{{:3d_modeling:meshmixer-select-flat-areas-poster.jpg?nolink400|}}]]\\
 [[Select a flat surface]]. [[Select a flat surface]].
- 
----- 
  
 [[Fill holes|{{:3d_modeling:meshmixer-fill-poster.jpg?nolink400|}}]]\\ [[Fill holes|{{:3d_modeling:meshmixer-fill-poster.jpg?nolink400|}}]]\\
Line 30: Line 37:
 {{:3d_modeling:meshmixer-snap-increments.jpg?nolink400|}}\\  {{:3d_modeling:meshmixer-snap-increments.jpg?nolink400|}}\\ 
 Adjust the snap increments with the arrow keys Adjust the snap increments with the arrow keys
 +
 +{{:3d_modeling:meshmixer-select_edge_of_hole.jpg|}}
  • 3d_modeling/meshmixer.txt
  • Last modified: 2020/03/25 07:25
  • by formlab